Difference between Check points & Output values

Check points are normally used to check the screen values, screen object properties to find out if there are any changes from the recorded version.

Where as output values are used to check the properties of the objects and these properties will be written to the data table columns in the sctipt.

Use the below code to validate if the checkpoint is passed or failed:
chk_PassFail = Browser(...).Page(...).WebEdit(...).Check (Checkpoint("Check1"))if chk_PassFail then MsgBox "Check Point passed"else MsgBox "Check Point failed"end if

Use the below code to stop any exceptions that will raise due to check point failure.Reporter.Filter = rfDisableAll 'Disables all the reporting stuff
chk_PassFail = Browser(...).Page(...).WebEdit(...).Check (Checkpoint("Check1"))
Reporter.Filter = rfEnableAll 'Enable all the reporting stuff
if chk_PassFail then
MsgBox "Check Point passed"
else
MsgBox "Check Point failed"
end if